7 Tips for Using a Thickness Planer

7 Tips for Using a Thickness Planer

A thickness planer is easy and safe to use and can help you in smoothing your wood and providing a good and high-quality finish to it. However, one must always keep a few tips in mind to get the most out of your thickness planer. If you’re interested in getting one, I’d recommend you go through a lot of reviews before getting one, Homeguyd has some strong recommendations.

In this article, we will be discussing a few safety and quality tips so that you can plane precisely while not compromising on your safety or the quality of the planed woods.

Tip 1:

Always feed your wood smoothly and gently into the machine and make sure that it is as flat to the machine’s bed as possible. You can do this by putting some downward pressure on the board on the in-feed side as you feed it in.

Tip 2:

Although chances of finding loose knots, nails, etc. are less likely, it is always a good idea to check your board with a magnetic wand before feeding it into the machine.

Thickness Planer

You can glue or remove the loose knots before you put it into the planer so that there are no projectiles. It will hardly take 5 minutes and will help you reduce the planning time too.

Tip 3:

You can use your thickness planer to plane woods into a similar thickness which are bound to be used together. However, it is not possible to get the same thickness usually so you have to be a little more careful with it.

For this reason, it is important that you feed your boards into the same part of the planer for the final pass. You can choose any side but just make sure that you run all the boards together through the same cutterhead part to ensure the same thickness level.

Tip 4:

It is important to keep a lookout for tear outs as it can happen quite frequently and can certainly ruin the look of your board. So, to avoid tear outs, you can sharpen your knives so that you get quality cut, even on difficult woods.

Tip 5:

Another efficient way to avoid a tear-out is by using a damp cloth to wipe down your board before feeding it into the planer. This will soften the wood fiber and will allow you a chance to avoid the tear outs but you should do this only as the last resort because you don’t want your planer to get wet too.

Tip 6:

Always be sure to wear a face mask, glasses, and earplugs to avoid sawdust getting inside your eyes, nose, ears, and so on. This will protect you from any accidents that might occur due to the dust getting into your sensory organs.

Tip 7:

Whenever you clean or make any repairs to your planer, always make sure to unplug it first so as to avoid any residual electrical energy from causing you harm. If you forget to do this, then you might end up getting hurt or might damage your planer while cleaning it.

Leave a Reply

Your email address will not be published. Required fields are marked *